Removing The Display - UNI-T UTS1000 Series Service Manual

Service Manual
3、 To reinstall, reverse the above steps.

Removing the Display

The following procedures describe display removal and replacement.
To prevent electrostatic damage to components, wear a properly grounded antistatic wrist and foot
•
strap during installation, and use an antistatic mat in a tested antistatic environment.
Remove the rear cover.
•
Remove the RF board
•
Removing the digital IF board
•
Remove the cover
•
Steps:
1、 Use a T10 Torque screwdriver to remove the 5 screws that fix the display, as shown in the figure below:
2、 Open the display screen carefully, and manually remove the FPC cable between the display screen and
the display adapter board, as shown in the figure below:
Instruments.uni-trend.com
UTS1000/3000 Series
21 / 25