Safety Instructions And Responsibility; General Safety Instructions; Use According To The Intended Purpose - Hohner IT 210 Operating Manual

1. Safety Instructions and Responsibility

1.1 General Safety Instructions

This operation manual is a significant component of the unit and includes important
rules and hints about the installation, function and usage. Non-observance can result
in damage and/or impairment of the functions to the unit or the machine or even in
injury to persons using the equipment!
Please read the following instructions carefully before operating the device and
observe all safety and warning instructions! Keep the manual for later use.
A pertinent qualification of the respective staff is a fundamental requirement in
order to use these manual. The unit must be installed, connected and put into
operation by a qualified electrician.
Liability exclusion: The manufacturer is not liable for personal injury and/or damage
to property and for consequential damage, due to incorrect handling, installation
and operation. Further claims, due to errors in the operation manual as well as
misinterpretations are excluded from liability.
In addition the manufacturer reserve the right to modify the hardware, software or
operation manual at any time and without prior notice. Therefore, there might be
minor differences between the unit and the descriptions in operation manual.
The raiser respectively positioner is exclusively responsible for the safety of the
system and equipment where the unit will be integrated.
During installation or maintenance all general and also all country- and application-
specific safety rules and standards must be observed.
If the device is used in processes, where a failure or faulty operation could damage
the system or injure persons, appropriate precautions to avoid such consequences
must be taken.

1.2 Use according to the intended purpose

The unit is intended exclusively for use in industrial machines, constructions and
systems. Non-conforming usage does not correspond to the provisions and lies
within the sole responsibility of the user. The manufacturer is not liable for damages
which has arisen through unsuitable and improper use.
Please note that device may only be installed in proper form and used in a
technically perfect condition - in accordance to the "Technical Specifications" (see
chapter 8). The device is not suitable for operation in explosion-proof areas or areas
which are excluded by the EN 61010-1 standard.
It210_01a_oi_e.docx / Jan-20 Page 4 / 21
www.hohner-elektrotechnik.de 5