Table of Contents
Advertisement
Trigger Cable Tension Adjustment
1. Relieve pressure. See page 17.
2. Be sure the gun is properly mounted in the holder as
instructed on page 14.
3. Pull the actuator lever (40s) forward and hold it. Lift
up on the gun trigger (A) until there is slight resis-
tance. Visually check to see if there is about 1/32 to
1/16 in. gap between the trigger lever (B) and where
the gun trigger touches the bar.
4. To adjust the tension, loosen the screw (C) in the
block (40n). Slide the block forward to increase the
gap and backward to decrease the gap. Tighten the
screw.
5. Recheck the gap and adjust as needed.
CAUTION
Do not allow the cable (40a) to rub against the
outside edges of the slot (H) in the block (40n), to
prevent premature wear of the cable. Rotate the
block slightly to eliminate rubbing.
See Fig. 6, DETAIL A.
How To Mount the Gun
See Fig. 6
FORWARD
40s
A
B
DETAIL A
Be sure end jacket of cable
seats here. Keep jacket and
seat clean
40n
Shown Inverted
Fig. 6
40a
40k
40n
1/32 – 1/16 in.
(1–2 mm)
06966
40a
40k
H
0024
308685
C
15
Advertisement
Table of Contents
