Table of Contents
Advertisement
Notes on changing the lens
When changing the lens, if dust or debris gets inside the camera and adheres to the surface
of the image sensor (the part that converts the light to an electric signal), it may appear as
dark spots on the image, depending on the shooting environment.
This camera is equipped with an anti-dust function that causes the image sensor to vibrate a
little when the power is turned off, and the camera's image sensor is coated with an anti-
dust coating to prevent dust from adhering to the image sensor. However, always make sure
to attach/remove the lens quickly away from dusty locations.
[23] How to Use
Setting the date and time
When you turn on the camera for the first time or after you have initialized the functions, the
setting screen for the date and time appears.
1. Set the power switch to ON to turn on the camera.
The setting screen for the date and time appears.
2. Check that [Enter] is selected on the screen, then press
3. Select your desired geographic location, and then press
4. Select a setting item using the up/down side of the control wheel or by turning the
control wheel, then press
5. Set [Daylight Savings], [Date/Time], and [Date Format] using the up/down/left/right
sides, then press
Midnight is indicated as 12:00 AM, and noon as 12:00 PM.
6. Repeat steps 4 and 5 to set other items, then select [Enter] and press
To cancel the date and time setting procedure, press the MENU button.
Note
This camera does not have a function for inserting the date on images. You can insert the
date on images and then save and print them using PlayMemories Home.
If the date and time setting is cancelled halfway, the setting screen for the date and time
appears every time you turn on the camera.
Preparing the camera
in the center.
in the center.
Setting the date and time
on the control wheel.
.
in the center.
Advertisement
Table of Contents
