Section 4 - Maintenance And Troubleshooting; Routine Maintenance; Unit Overload - Miller Electric INTEGRA 151S Owner's Manual

SECTION 4 – MAINTENANCE AND TROUBLESHOOTING

4-1. Routine Maintenance

3 Months
Replace unreadable labels.
6 Months

4-2. Unit Overload

If unit is used beyond capacity (excessive wire feed, shorted output, etc.), wire feeds but is not energized. Release gun
trigger to reset this condition.
OM-189 107 Page 10
Y Disconnect power before maintaining.
Clean and tighten weld terminals.
Blow out or vacuum inside. During
heavy service clean monthly.
Repair or replace
cracked weld cable.
OR