Multi Tap Delay; Ns.suppressor (Noise Suppressor) - Boss VF-1 Owner's Manual

MULTI TAP DELAY

This is an effect in the "Multi tap delay (20 tap)" algorithm.
This parameter creates a distinctive effect (such as a thicker
sound) by applying a delayed sound to the direct sound.
Multi tap delay lets you make independent settings for each
of 20 tap delays.
EFFECT
This parameter turns the multi tap delay effect on/off.
RATIO (time ratio)
This setting maintains the time ratio set in the DELAY TIME
[1]–[20] settings and extends / shortens this ratio to the
overall time.
TAP [1]–[20] DELAY TIME
Adjust the delay time for each delay (TAP [1]–[20]).
* If this is set to BPM, the MASTER BPM (p.105) value that is
set for each patch will determine the delay time, so that the effect
will match the tempo of the song. However if the BPM value is
low, the effect will synchronize to twice or four times the BPM.
TAP [1]–[20] FINE TIME
Make fine adjustments to the delay time for each delay (TAP
[1]–[20]).
TAP [1]–[20] PAN L:R
Adjust the stereo location (pan) of each delay sound (TAP
[1]–[20]).
L0-100:
Adjust the output level of the L channnel.
R0-100:
Adjust the output level of the R channnel.
* When L100 is set, only the L channel will be used, while only
the R channel will be used when R100 is set.
TAP [1]–[20] LEVEL
Adjust the volume of each delay sound (TAP [1]–[20]).
FB DELAY (feedback delay time)
Adjust the delay time for the feedback sound.
* If this is set to BPM, the MASTER BPM (p.105) value that is
set for each patch will determine the delay time, so that the effect
will match the tempo of the song. However if the BPM value is
low, the effect will synchronize to twice or four times the BPM.
The function of each parameter
FB FINE (feedback delay time)
Make fine adjustments to the delay time for the feedback sound.
FB LEVEL (feedback level)
Adjust the amount of feedback. Higher settings will result
more delay repeats.
LOW CUT (low cut filter)
The Low Cut Filter cuts the frequency contents that are lower
than the set frequency. This parameter adjusts the frequency
where the low cut filter starts working. When it is set to
"FLAT," the high cut filter does not work at all.
HIGH CUT (high cut filter)
This parameter adjusts the frequency where the high cut
filter starts working. When it is set to "FLAT," the high cut
filter does not work at all.
DIR LEVEL (direct level)
Adjusts the volume of the direct sound.
FX LEVEL (effect level)
This adjusts the volume of the delay sound.
NS.SUPPRESSOR
(Noise Suppressor)
This effect reduces the noise and hum. Since it suppresses the
noise in synchronization with the envelope of the sound (the
way in which the sound decays over time), it has very little
effect on the guitar sound, and does not harm the natural
character of the sound.
EFFECT
This parameter turns the noise suppressor effect on/off.
DETECT (detector in)
This is the parameters for both "STEREO MULTI" and "10
GRAPHIC EQ." It selects the input source which will control
the nose suppressor.
L:
It will be controlled by the input source of channel L.
R:
It will be controlled by the input source of channel R.
LINK:
It will be controlled by the input source whose level is
greater.
107