Table of Contents
Advertisement
Section 6. Appendices
About the VF-1's digital output
The VF-1 provides a coaxial connector (DIGITAL OUTPUT)
for digital output.
This section explains how to make connections to other
devices when using the VF-1's DIGITAL OUT, and describes
the specifications of the digital signal that is output from the
VF-1.
Digital output signal
The VF-1 transmits an EIAJ CP-1201, S/P DIF Format digital
audio signal.
About the EIAJ CP-1201 format
This is a format defined by the Electric Industries Association
of Japan for connections between consumer and broadcast
digital audio devices.
About S/P DIF Format
S/P DIF, short for Sony/Philips Digital Interface Format, is
one standard used for sending and receiving stereo digital
signals between digital devices.
Connecting the VF-1 to a
digital audio device
Use a video cable (75
unbalanced) to make connections.
Turn off the power of the VF-1 before connecting a digital
audio device to it. If the power is on when a digital audio
device is connected to the VF-1, malfunctions can occur.
fig.6-00
DIGITAL OUTPUT
DIGITAL INPUT
Digital OUT specifications
Format:
Connector:
Electrical characteristics:
Impedance:
VF-1 operation using the FC-200
When an FC-200 MIDI foot controller (optional) is connected,
you can control the VF-1 using pedal operations. This section
includes all the information you need when using an FC-200
connected to the VF-1.
VF-1 and FC-200 connections
fig.6-01
* If you wish to use a foot switch to switch modes on the FC-200,
connect a BOSS FS-5U foot switch (optional) to the Mode jack
of the FC-200.
* If connecting a footswitch (FS-5U; optional) to the CTL 1/2
jack, set the polarity switch as shown below. Unless the polarity
switch is set correctly, the foot switch will not work properly.
fig.6-02
EIAJ CP-1201, S/P DIF
coaxial connector
RS-422A
75
unbalanced
MIDI IN
MIDI OUT
FC-200
Polarity switch
127
Advertisement
Table of Contents
