Table of Contents
Advertisement
Transmitting VF-1 data
(Bulk Dump)
The VF-1 can use exclusive messages to set another VF-1 to
the same settings, or to transmit its settings to a device such
as a sequencer for storage. The process of transmitting such
data is called Bulk Dump.
The following data can be transmitted. You can select from
the following four types of transmission.
ALL:
Contents of both UTILITY and PATCH
UTILITY:
Utility parameters
PATCH:
All user bank patches
TEMP:
Patch settings currently being edited
Connections
When saving data on a sequencer
Make connections as shown below, and set the sequencer to a
condition ready to receive exclusive messages (p. 132).
* For details on sequencer operation, refer to the manual for the
sequencer you are using.
fig.5-13
MIDI OUT
MIDI IN
Sequencer
When copying data to another VF-1
Make connections as shown below, and set the Device ID
(p.123) of both units to match.
fug.5-14
MIDI OUT
MIDI IN
Transmission Procedure
fig.5-15
1. Press [UTILITY].
2. Rotate [NUMBER] to select "MIDI."
fig.5-03
3. Press [ENTER].
4. Use PARAMETER [
fig.5-06
5. Rotate [VALUE] to select the data that you wish to
6. Press [ENTER] to execute the Bulk Dump.
The message "Bulk Dump..." will appear while the data is
being transmitted. When the bulk dump is completed, the
message "Complete!" will appear, then the previous screen
will reappear.
7. Press [UTILITY] to return to Play mode.
* If you press [EXIT] you will return to step 2. If you press
Transmit device
While a bulk dump is being executed, the VF-1 will ignore
any operations of its controls.
Receive device
Section 5. Using MIDI to Operate the VF-1
][
DUMP."
transmit.
[EXIT] once again, you will return to Play mode.
1,7
2,3,5,6
4
] to select "MIDI BULK
125
Advertisement
Table of Contents
