Using Delay; Using A Filter; Delay; Filter (1/2) - Boss Dr.Sample SP-202 Owner's Manual

33
Filter cannot be used in the following situations
• On stereo samples that were recorded to banks C/D
• When reverse playback is used
. .
The filter can be adjusted independently for each sample.
If you select FILTER 2 and rotate the knob to left and
right as you play the sample, a "wah" effect can be pro-
duced.
. .
3,
Rotate the CONTROL knob to adjust the effect of
the filter (cutoff frequency).
Rotating the knob toward the left will make the tone
darker.
2.
Press the FILTER 1 or FILTER 2 button to make
the button light.
FILTER 1: This filter attenuates the high frequency
range of the sound. (Low Pass Filter)
FILTER 2: This filter applies resonance to give a tone a
distinctive character.
1.
Press the pad which contains the sample to which
you wish to apply a filter. (Specify the current
pad)
The pad will light, and the sample will play.
3
CONTROL
EFFECTS
By using a filter you can make the tone brighter/darker, or
add a distinctive character.
I
Using a
filter
• Delay cannot be used in the following situations
• On stereo samples
• On samples that were recorded to banks CID
• When reverse playback is used
3.
Rotate the CONTROL knob to adjust the delay
time.
The delay time can be adjusted in the following 13 steps
relative to the BPM value (tempo):
64th note, dotted 64th note, 32nd note, dotted 32nd
note, 16th note, dotted 16th note, 8th note, dotted 8th
note, quarter note, dotted quarter note, half note, dotted
half note, and whole note.
Rotate the knob toward the left to shorten the delay time,
or toward the right to lengthen the delay time.
• You can set the delay time independently for each sam-
ple.
2.
Press the DELAY button to make it light.
1.
Press the pad which contains the sample to which
you wish to apply delay. (Specify the current pad)
The pad will light, and the sample will play.
3
When delay is activated, the sample will play a second time
(producing the delayed portion), beginning a predetermined
amount of time after the start of the first playback.
When the sample playback stops (the pad goes dark), the
delay sound will also stop, and will not sound further.
I
Using
delay