Limit Thermostat And Thermal Fuse (Electric Models); Cabinet - Maytag Amana NDE2330AYW Service Manual

Disassembly Procedures
!
WARNING
Limit Thermostat and Thermal Fuse
(Electric Models)
1. Disconnect power supply to unit.
2. Remove heating element, see "Heating Element
(Electric Models)" procedure.
3. Reverse procedure to reassemble.

Cabinet

1. Disconnect power supply to unit.
2. Remove control hood assembly, see "Control Hood
Assembly" procedure.
3. Remove front panel, see "Front Panel" procedure
steps 1 – 3.
4. Remove screws securing cabinet top to side panels.
5. Raise cabinet top to a vertical position.
6. Carefully disconnect wire harness and feed harness
through cabinet top access hole.
7. Disengage belt from motor and idler pulleys.
8. Remove front bulkhead, see "Front Bulkhead"
procedure.
9. Carefully remove cylinder out through front of dryer.
Cabinet
13
Base
©2004 Maytag Services
To avoid risk of electrical shock, personal injury, or
death, disconnect power and shut-off gas supply valve
to unit before servicing.
Gas Models
1. Remove burner tube attaching screw from right side
of burner housing.
2. Gently move burner tube toward rear of dryer to
disengage tab from slot on left side of burner
housing.
3. Remove screw securing front of burner housing to
dryer base and move housing away from heat
shroud.
4. Remove screw securing burner housing to heat
shroud.
5. While supporting rear bulkhead, remove screws
securing rear bulkhead to dryer cabinet back, then
lift complete assembly out of dryer.
6. Remove screws securing each rear cabinet top
hold-down brackets.
7. Remove wire harness clips.
8. Remove locators and screws.
9. Remove screws from front edge at each side of
cabinet. Then remove remaining screws from around
bottom of cabinet and lift cabinet off base.
10.Reverse procedure to reassemble.
Electric Models
1. Remove two screws securing element and plate to
heater box, then pull element down and away from
7
heater box.
2. Remove screw securing heat shield to dryer base.
3. While supporting bulkhead, remove screws holding
bulkhead to rear of dryer cabinet, and remove
assembly out of dryer.
4. Remove screw securing exhaust duct to dryer
cabinet and pull duct out of cabinet.
5. Remove screws from each rear cabinet top
hold-down bracket.
6. Remove screw securing access plate and remove
plate.
7. Remove wire harness clips.
8. Remove locators and screws.
9. Remove screws from front edge at each side of
cabinet. Then remove remaining screws from around
bottom of cabinet and lift cabinet off base.
16023020 29