Timer Does Not Advance In Automatic Cycle; Clothing Is Too Hot When Removing From Dryer - Maytag Amana NDE2330AYW Service Manual

Troubleshooting Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect power to dryer and shut-off gas supply
before servicing, unless testing requires it.

14. Timer does not advance in AUTOMATIC cycle.

Possible Cause
Failed cycling thermostat.
Failed resistor.
Heater assembly does not heat or burner
does not ignite.
Heater assembly or burner shuts off
prematurely.
Improper or inadequate exhaust system.
Weather hood flapper maybe restricted.
Drying load too large.
Timer motor is inoperative.
Possible air leaks at seals.
Failed moisture sensing control.

15. Clothing is too hot when removing from dryer.

Possible Cause
Improper or inadequate exhaust system.
Weather hood flapper may be restricted.
Clothing is removed from dryer before cycle
has been completed.
Failed cycling thermostat or failed
thermostat heater on DELICATE cycle.
Inoperative timer (not allowing cool down).
Possible air leaks at seals.
Failed timer.
Failed moisture sensor.
18
!
W ARNING
• Test cycling thermostat and replace if failed.
• Test resistor and replace if failed.
• See Troubleshooting Procedure (# 6. Heating assembly does not
heat or burner does not ignite).
• See Troubleshooting Procedure (# 9. Heater assembly or burner
shuts off prematurely).
• See "Installation Instructions" for exhaust requirements.
• Remove some articles to reduce load size.
• Select a drying cycle and activate start switch.
• Rotate timer knob until signal sounds.
• Release timer knob.
• Signal should stop within ten minutes. If not, replace timer.
• Check and replace any failed seals in the following areas:
• Seal between loading door and front panel.
• Seal between front panel and front bulkhead.
• Seal between blower cover and air duct.
• Seal between cylinder and front or rear bulkhead.
• Seal between upper and lower air ducts.
• Test moisture sensing control and replace if failed.
• See "Installation Instructions" for exhaust requirements.
• Allow dryer to go through the cooling down cycle before removing.
• Test cycling thermostat or thermostat heater and replace if failed.
• Test timer and replace if failed.
• Check and replace any failed seals in the following areas:
• Seal between loading door and front panel.
• Seal between front panel and front bulkhead.
• Seal between blower cover and air duct.
• Seal between cylinder and front or rear bulkhead.
• Seal between upper and lower air ducts.
• Test timer and replace if failed.
• Test moisture sensor and replace if failed.
16023020
Result
Result
©2004 Maytag Services