Nw User Property (Obtain Network User Property) - Olivetti PGL2645 Operation Manual

User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration

NW User Property (Obtain Network User Property)

Set the required information to obtain the network user property from the LDAP server.
NOTE
• This setting only appears when the "Login Type" of "User Login" is set to [Netwk Authentic.] and the "Server Type"
is set to [NTLM] or [Kerberos].
Enabling User Login Administration (page 9-3)
• Setting to obtain network user information is performed from the operation panel. The details of the information to be
obtained should be set with Embedded Web Server RX.
Embedded Web Server RX User Guide
1
2
Display the screen.
1
[Menu] key > [▲] [] key > [User/Job Account] > [OK] key
NOTE
If the login user name entry screen appears during operations, enter a login user name
and password, and select [Login]. For this, you need to login with administrator
privileges.
The factory default login user name and login password are set as shown below.
Login User Name:
Login Password:
2
[▲] [▼] key > [User Login Set.] > [OK] key
Configure the settings.
[▲] [] key > [NW User Property] > [OK] key
The setting items are as follows.
Item
Off/On
Authenticat Type
PG L2645: 4500 PG L2650: 5000
PG L2655: 5500
PG L2645: 4500 PG L2650: 5000
PG L2655: 5500
Set whether or not network user information is acquired.
Value: Off, On
Set the authentication method.
Value: Simple, SASL
9-10
Descriptions