Table of Contents
Advertisement
15. Performing Non-Image Area Erase
Check
Note:
Perform the below at the site where customer
uses the machine.
(1) Select the Non-Image Area Erase Check func-
tion as follows: Machine → Non-Image Area
Erase Check.
(2) Open fully the DF.
Note:
• Do NOT place a document on the document
glass.
• Clean the document glass if dirty.
(3) Press the Start key.
(4) Make sure that "Result" is "OK."
Note:
If "Result" is "NG1" or "NG2", review the place and
direction of installation, or take measures to block
the light source (by covering it, etc.), then perform
installation checking again.
(If a fluorescent light or other bright light sources
exist right above the main body, the light source
can hinder installation checking and cause opera-
tion errors in the Non-Image Area Erase Check.
For detailed information, see the service manual.)
(5) Touch "OK."
16. Configuring other options
(1) If any of the following options are installed, re-
fer to the "Configuration procedures" of the in-
stallation manual for each option and configure
the option(s).
• Authentication Unit AU-201S/AU-102
• Local Interface Kit EK-P09
• Local Interface Kit EK-P10
• Upgrade Kit UK-221
• FAX Kit FK-517
• Clean Unit CU-202
• Network Fax
(2) Exit from the Service Mode and return to the
initial screen.
17. Restarting the machine
Open the power switch cover on the right side of the
main body, turn OFF the main power switch, then
turn it ON again after more than 10 second.
18. Connecting the network cable
(1) Connect the main body and networking equip-
ment (HUB) using the network cable.
Note:
The following shows the recommended network
cables that correspond to each communication
speed.
• 10BaseT/100BaseTX: Category 5
• 1000BaseT: Category 5E, Category 6
LED1
LED2
Network port
(2) Check LEDs for lighting conditions.
LED1：
Should light up steadily if the link network con-
nection has been made.
LED2：
Should blink according to the communications
status of the ACT network.
E-9
Advertisement
Table of Contents
