Table of Contents
Advertisement
Facing Material
• Facing and/or finishing materials must not interfere with
air flow through louvers or decorative fronts.
• Facing and/or finishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
Finishing - Hearth
See Inside Fit or Overlap Method sections to determine
the necessary requirements for installation of a non-
combustible hearth for this model. Only hearths made of
non-combustible materials are allowed.
Decorative facing material thickness is measured from
the face of the installed non-combustible board. See Fig-
ure 10.2 and Figure 10.3.
The fronts for this appliance are compatible with non-
combustible materials. See Figure 10.2 and Figure 10.3.
Refer to Section 1.E and 1.F of this manual for definitions
and qualifications of non-combustible and combustible
materials.
Specific requirements for each method of installation are
described in this section.
Installation of finishing materials can be accomplished by
either the "overlap" or "inside-fit" method, depending on
what type of decorative front is to be installed. See Figure
10.1 and 10.2. Overlap fit decorative fronts include the
Quattro and Loft Forge. The Clean Face Trim Front (CFT)
can be either an inside fit or an overlap fit. See Table 1.
Decorative Front
Clean Face Trim (CFT)
Quattro/Loft Forge
Table 1.
Heat & Glo • MEZZO36-B/ST-B, MEZZO48-B/ST-B, MEZZO60-B/ST-B, MEZZO72-B/ST-B Installation Manual • 2300-973 Rev. R • 12/18
Finishing Method
Material Thickness
Inside Fit
Overlap Fit
Overlap Fit
1/2 IN. THICK WALL
SHEATHING
Figure 10.2 Finishing and Facing Materials - Single-Sided Models
Included & Not Used (Option #1)
1-4 inches
Included & Used (Option #2)
0-1 inch
Included & Used
0-1 inch
Not included
NON-COMBUSTIBLE
FINISHING MATERIAL
OVERLAP FIT = 0-1 IN. THICK
INSIDE FIT = 1-4 IN. THICK
FINISHING
GUARDS
BOTTOM
FINISHING
TEMPLATE
Trim Ring
51
Advertisement
Table of Contents
