Download Print this page

Kenwood TK-7189 Service Manual page 8

Vhf fm transceiver, uhf fm transceiver
Hide thumbs Also See for TK-7189:

Advertisement

TK-7180/7189/7180H/8180/8189/8180H
■ Connect the KRK-10 main panel to the rear panel
with the cable
8. Insert one 14-pin connector of the cable (E30-7514-15)
into the connector (CN3) of the interface unit (A/2) of the
main panel. ( !1 )
Note : Insert the connector that has a sticker onto the
cable to the connector of the main panel.
9. Secure the cable bush on the main panel and fit the water-
proof packing (orange) ( !2 ) securely over top.
4. Voice Guide & Storage Unit (VGS-1 : Option)
4-1. Installing the VGS-1 unit in the transceiver
1. Remove the cabinet, top packing and shielding plate of the
transceiver.
2. Attach two cushions to VGS-1 as shown in Figure 4. ( q )
Note : Be sure not to cover the connector with the bottom
cushion.
3. Insert the VGS-1 connector (CN1) into the TX-RX unit (B/3)
connector (CN403). ( w )
Note : You must setup using the KPG-96D.
8
INSTALLATION
CN4
!8
!5
!7
!6
KRK-10 rear panel
!4
q
10. Install the molded cover ( !3 ) over the connector on the
main panel and secure it with two screws ( !4 ).
11. Insert the other 14-pin connector of the cable into the
connector (CN4) of the interface unit (B/2) of the rear
panel. ( !5 )
12. Secure the cable bush on the rear panel and fit the water-
proof packing (orange) ( !6 ) securely over top.
13. Install the molded cover ( !7 ) over the connector on the
rear panel and secure it with two screws ( !8 ).
!8
Note : A cable can be connected from the left side as shown
in the Figure 3-5 or from right side.
However, the 14-pin connector must be connected to correct
direction.
Sticker
CN3
!1
!2
!3
!4
!2
(Right side)
Fig. 3-5
Cushion
(G13-1994-04)
20 x 30 x 12 mm
VGS-1
Cushion
(G13-1992-04)
21 x 21 x 2.5 mm
KRK-10 main panel
Sticker
CN1
w
CN403
Fig. 4

Advertisement

loading

This manual is also suitable for:

Tk-7180hTk-7180Tk-8180Tk-8180hTk-8189