Kenwood TK-7189 Service Manual page 11

3M Double coated cushion
No. 4016 (or No. 4416)
30 x 25 mm
GPS receiver
3M Double coated cushion
No. 4016 (or No. 4416)
30 x 25 mm
Fig. 7-2
w
Fig. 7-3
7-2. Installing the GPS receiver together with the VGS-1
1. Remove the cabinet, top packing and shielding plate of the
transceiver.
2. Remove the front panel from the transceiver.
3. Attach a cushion to the bottom of the VGS-1 as shown in
Figure 7-5.
Note : Be sure not to cover the connector with the cush-
ion.
TK-7180/7189/7180H/8180/8189/8180H
INSTALLATION
4. Insert the VGS-1 connector (CN1) into the TX-RX unit (B/3)
connector (CN403).
5. Perform step 3 to 6 of "7-1. Installing the GPS receiver"
described on page 10.
Note : You must setup using the KPG-96D.
q
GPS receiver
TX-RX unit (B/3)
Solder land
GND (GND)
RXD1
TXD1
TXD2
RXD2 (DATA OUT1)
OPT1
OPT3
OPT4
OPT5
5E (+5V)
DTI
TCTL
TXO
AUDIH
OPT2
STON
RXEO
TXI
RXEI
OPT6
8C
Fig. 7-4
VGS-1
CN1
CN403
Fig. 7-5
11