Standard Or Angle Mounting Instructions; Motor Housing - Honeywell BIRNHAM Manual

STANDARD OR ANGLE MOUNTING INSTRUCTIONS

6. Partially loosen the two set screws in the yoke at
the top of the motor housing (Fig. 6).
7. Remove the downrod pin and downrod clip from
the downrod (Fig. 7).
Downrod Pin
Downrod Clip
8. Thread the wires from the motor housing through
the yoke cover, canopy and out through the top of
the downrod (Fig. 8).
Fig. 6
Fig. 7
Fig. 8
7
Set Screws
Downrod
Clip
Downrod
Pin
Downrod
Canopy
Yoke
Cover
Motor
Housing