D-Link DAP-1900 User Manual page 35

Section 3 - Configuration
IPv6 - Autoconfiguration (SLAAC/DHCPv6)
Select Autoconfiguration (SLAAC/DHCPv6) to have the
My Internet Connection
is DAP-1900 automatically receive an IPv6 address from the
uplink router.
Obtain a DNS server
You can obtain IPv6 DNS server information automatically,
address automatically or configure DNS servers manually by selecting Use the
following DNS address.
Primary DNS
For manual settings, enter the primary IPv6 DNS server address.
Secondary DNS
For manual settings, enter the secondary IPv6 DNS server
address. This is optional but will provide backup if the primary
server fails.
Select Static IPv6 to manually assign an IP address to the
My Internet Connection
is DAP-1900.
IPv6 Address Assign an IPv6 address. This address should be outside of the
uplink router's DHCP address pool.
Subnet Prefix Length Enter the length of the IPv6 subnet prefix for identifying the
IPv6 subnetwork.
Default Gateway
Enter the default gateway.
Primary DNS
Enter the primary IPv6 DNS server address.
Secondary DNS
Enter the secondary IPv6 DNS server address. This is optional
but will provide backup if the primary server fails.
IPv6 -
Select Local Connectivity Only to set an IPv6 address only
My Internet Connection
is for the local network.
LAN IPv6 Link-Local The link-local address of the DAP-1900 is used only within
Address the local network specific to a physical interface.
D-Link DAP-1900 User Manual
IPv6 - Static IPv6
Local Connectivity Only
32