Table of Contents
Advertisement
∫ Do not connect to the wireless network you are not authorised to use
When this unit utilises its wireless LAN function, wireless networks will be searched automatically. When this happens, wireless networks that you are not
*
authorised to use (SSID
) may be displayed, however do not attempt to connect to the network as it may be considered as unauthorised access.
* SSID refers to the name of device that is used to identify a network over a wireless LAN connection. If the SSID matches for both devices, transmission is
possible.
∫ Before use
To use the wireless LAN function on this unit, you need a wireless access point or a device connected that has wireless LAN functionality.
For the operations and settings of the device you are using, such as iPhone/iPad or Android handset, refer to the operating instructions for your device.
∫ This unit is WPS-compatible
WPS (Wi-Fi Protected Setup
™
) is a function that allows you to easily set up a connection with a wireless LAN device and make security-related settings.
@
NOTE
0 This unit cannot be connected to wireless LAN devices via public wireless LAN environments.
0 The wireless access point must be compatible with IEEE802.11b, IEEE802.11g, or IEEE802.11n.
0 This unit uses the 2.4 GHz frequency band. You cannot establish a wireless LAN connection using the 5 GHz frequency band.
0 When using a wireless access point, we strongly recommend that you set a encryption to maintain information security.
0 Depending on the signal status, it may not be possible to connect to wireless LAN devices via a network.
0 If the wireless LAN connection is not working well, set up so the wireless LAN transmitter (l 18) faces towards the wireless LAN device.
0 When the battery indicator (
0 When you are using the wireless LAN function of this unit, the wireless LAN transmitter (l 18) may become warm but this does not indicate a
malfunction.
Preparing for connection (wired LAN) [CX10]
Use the supplied USB HOST conversion cable and USB ethernet adaptor to connect a LAN cable.
≥ Use the following cable for connections:
*
j LAN cable (STP
, category 5 or better, maximum 100 m)
* STP (Shielded Twisted Pair)
USB HOST conversion cable
A
USB ethernet adaptor
B
LAN cable (commercially-available)
C
Micro-A
D
1
Connect the USB HOST conversion cable to the USB terminal.
2
Connect the USB HOST conversion cable and the USB ethernet adaptor.
3
Insert the LAN cable into the LAN terminal of the USB ethernet adaptor.
Connect the LAN cable to another wired LAN compatible device.
Chapter 9 Network Connection — Network connection
) is flashing red, the connection with other equipment may not start or the connection may be disrupted.
- 176 -
Advertisement
Table of Contents
