Table of Contents
Advertisement
Preventing unintentional erasing
Writing, erasing and formatting data is prohibited by setting the write-protection switch A of the memory card to the LOCK side.
Status of the card access lamp and memory card
Card access lamp
Orange (illuminated)
Green (illuminated)
Orange (flashing)
Orange (rapidly flashing)
Green (slowly flashing)
Off
Off (For the
)
CX10
Chapter 3 Preparation — Preparing the memory card
Recording target
Recording possible
Accessing card
Recognizing memory card
Error
No remaining recording capacity
Write-protected
Recording not possible
No memory card inserted
Illegal format
Card not supported
During card reader mode
Setting to [NETWORK] menu →
[NETWORK FUNC] → [NDI|HX]
- 36 -
Memory card status
Both loading/writing are permitted. Current recording target.
Both loading/writing are permitted.
Loading/writing are currently being performed.
The memory card is being recognized.
An error has occurred. This will flash even if the memory card is not
inserted when an error has occurred.
No recording capacity left on the memory card. Only loading is possible.
The write-protection switch of the memory card is set to the LOCK side.
It cannot record with the recording format that is currently set. Change the
recording format or use a memory card compatible with the recording
format to record.
A memory card has not been inserted.
It is not the correct format. Reformat the card.
This is a card that cannot be used with the unit, such as MMC (Multi Media
Card).
The card 1 access lamp/card 2 access lamp turns off when not accessing.
Cannot record and play back. The functions other than recording and
playback (loading of the scene file, etc.) can be used.
Advertisement
Table of Contents
