Table of Contents
Advertisement
Saving VK-88 Settings on an
External Sequencer
(Bulk Dump)
You can connect the VK-88 to an external sequencer, then
save VK-88 registrations, and system settings on it. This
function is called "bulk dump."
Connect the VK-88 to your sequencer
1.
Make sure that the power of the VK-88 and your
sequencer is off.
NOTE
Turn off the power of the VK-88 and the other device
before making connections. If you connect an external
device when the power is turned on, damage or
malfunctions may occur.
2.
Use commercially-available MIDI cables to connect the
VK-88 to your sequencer.
fig.03-04
• Connect the VK-88's MIDI OUT connector to the
sequencer's MIDI IN connector
3.
Turn on the power of the external sequencer and the
VK-88.
4.
Turn off the Thru function of your sequencer.
NOTE
For details on setting the Thru function of your
sequencer, refer to the owner's manual of your
sequencer.
MIDI IN
Connecting the VK-88 to External Devices
Save the settings
5.
Hold down the [BANK] buttons, and press the
ROTARY SOUND [BRAKE] button.
The VIBRATO AND CHORUS [UPPER] button's
indicator will blink.
6.
Start recording on your sequencer.
7.
Press the VIBRATO AND CHORUS [UPPER] button to
begin saving the settings.
While the settings are being saved, the D BEAM type
indicators will light in succession, starting from the
bottom.
When the save has been completed, all indicators of the
D Beam Type will blink.
8.
Press the [H-BAR MANUAL] button.
9.
Stop recording on your sequencer.
■ Loading Back Data That's Been
Saved on an External
Sequencer
1.
Make sure that the power of the VK-88 and your
sequencer is off.
NOTE
Turn off the power of the VK-88 and the other device
before making connections. If you connect an external
device when the power is turned on, damage or
malfunctions may occur.
2.
Use commercially-available MIDI cables to connect the
VK-88 to your sequencer.
Connect the VK-88's MIDI IN connector to the
sequencer's MIDI OUT connector
3.
Turn on the power of your sequencer and VK-88.
4.
Play back your sequencer.
When the playback has been completed, all indicators of
the VIBTATO AND CHORUS Type and VIBRATO AND
CHORUS [UPPER] button will blink.
5.
When the external sequencer has finished playing
back, press the VIBRATO AND CHORUS [UPPER]
button.
The data from the external sequencer has thus been
loaded into the VK-88.
87
Advertisement
Table of Contents
