Honda TALON SXS1000S4X 2022 Owner's Manual page 242

6. Return the gear change tool to the storage compartment.
7. Check that "E" is blinking. Next, tighten the emergency valve.
Proceed to "E" is blinking.
If "–" is not displayed in the gear position indicator and you change
the gear position by using the gear change tool, the DCT system will
automatically stop. To reactivate the system, turn the ignition switch
to the OFF (w) position, and then turn it back to the ON (q) position.
"E" is blinking:
Tighten the emergency valve. Perform the following procedure.
1. Turn the ignition switch to the OFF (w) position to stop the
engine.
2. Loosen the bolt and release the lock plate, and turn the
emergency valve all the way in.
RIGHT REAR
emergency valve
3. Return the lock plate and tighten the bolt securely.
If the Transmission Is Not
Functioning Properly
Taking Care of the Unexpected
bolt
to unlock
lock plate
(cont'd)
233