Stihl RMI 522.0 C Instruction Manual page 180

– Create a new mowing plan (
Fault:
Mowing operations are significantly
shorter than usual
Possible cause:
– Grass is very high or too wet
– Machine (mowing deck, drive wheels) is
very dirty
– Battery has reached end of service life
Remedy:
– Adjust the cutting height (
Set the rain sensor ( 11.11)
Change the active times (
– Clean the machine ( 16.2)
– Replace the battery – observe
corresponding recommendation in the
display ( ), ( 24.)
Fault:
The robotic mower is docked, the battery is
not charging
Possible cause:
– Battery does not need to be charged
– Docking station not connected to power
supply
– Incorrect docking
– Charging contacts corroded
– Machine is in standby
Remedy:
– No action necessary – battery charging
occurs automatically below a certain
voltage
– Check power supply to docking station
( 9.8)
– Place robotic mower in mowing area
and send it back to docking station
( 11.6), check for correct docking – if
necessary, correct position of docking
station ( 9.1)
– Replace charging contacts ( )
178
11.7) – Press any button to wake up robotic
mower – status screen appears
( 11.2)
Fault:
Docking not working
Possible cause:
– Uneven entry area to docking station
– Uneven areas around or underneath
docking station floor plate
– Docking station floor plate bent
– Dirty drive wheels or dirty floor plate
9.5)
– Perimeter wire incorrectly routed in
area of docking station
11.7)
– Ends of perimeter wire not cut
Remedy:
– Level out entry area to docking station
( 9.1)
– Level out uneven areas around or
underneath docking station floor plate
( 9.1)
– Ensure that floor plate is level and flat
( 9.1)
– Clean drive wheels and docking station
floor plate (
– Re-route perimeter wire – ensure
correct routing in area of docking
station (
– Cut perimeter wire as described and
route it without excess length – do not
roll up protruding ends (
Fault:
The robotic mower travels past the
docking station or docks at an angle
Possible cause:
– Wire signal affected by environmental
influences
16.2)
9.9)
9.10)
– Perimeter wire incorrectly routed in
area of docking station
Remedy:
– Link robotic mower and docking station
again – ensure that robotic mower is in
correct alignment to docking station
( 11.16)
– Re-route perimeter wire – ensure
correct routing in area of docking
station ( 9.9)
Check for correct connection of
perimeter wire ends in docking station
( 9.10)
Fault:
The robotic mower has crossed the
perimeter wire
Possible cause:
– Perimeter wire incorrectly routed,
clearances are not correct
– Slope inclination of mowing area too
steep
– Interference affecting robotic mower
Remedy:
– Check routing of perimeter wire
( 11.13), check clearances using
iMOW® Ruler ( 12.5)
– Check routing of perimeter wire; block
off areas with excessively steep slope
inclinations ( 11.13)
– Contact your STIHL specialist dealer
( )
Fault:
The robotic mower frequently becomes
stuck
Possible cause:
– Cutting height too low
– Drive wheels dirty
0478 131 9965 A - EN