Yamaha XJ6 2008 Owner's Manual page 57

2
3
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark
3. If the coolant is at or below the
minimum level mark, remove the
coolant reservoir breather hose
from the guide, and then remove
the coolant reservoir cap.
PERIODIC MAINTENANCE AND ADJUSTMENT
1
1
1. Coolant reservoir cap
2. Coolant reservoir breather hose
3. Guide
4. Add coolant to the maximum level
mark, and then install the coolant
reservoir cap. WARNING! Re-
move only the coolant reservoir
cap. Never attempt to remove
the radiator cap when the en-
gine is hot.
[EWA15161]
coolant is not available, use dis-
tilled water or soft tap water in-
stead. Do not use hard water or
salt water since it is harmful to
the engine. If water has been
used instead of coolant, replace
it with coolant as soon as possi-
ble, otherwise the cooling sys-
tem will not
7-13
against frost and corrosion. If
water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
2
the coolant as soon as possible,
3
otherwise the effectiveness of
the coolant will be reduced.
[ECA10472]
Coolant reservoir capacity (up to the
maximum level mark):
0.25 L (0.26 US qt, 0.22 Imp.qt)
5. Route the coolant reservoir breath-
er hose through the guide as
shown.
NOTICE: If
1. Coolant reservoir breather hose
2. Guide
be protected
7
1
2