Yamaha XJ6 2008 Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
Coolant temperature mode
1
4
1. Coolant temperature display
The coolant temperature display indi-
cates the temperature of the coolant.
NOTICE
Do not continue to operate the en-
gine if it is overheating.
Self-diagnosis device
1
1. Error code display
This model is equipped with a self-diag-
nosis device for various electrical cir-
ECA10021 cuits.
If a problem is detected in any of those
circuits, the engine trouble warning light
will come on and the display will indi-
cate an error code.
The self-diagnosis device also detects
problems in the immobilizer system cir-
cuits.
If a problem is detected in the immobi-
lizer system circuits, the immobilizer
system indicator light will flash and the
display will indicate an error code.
4-10
TIP
If the display indicates error code 52,
this could be caused by transponder in-
terference. If this error code appears,
try the following.
1. Use the code re-registering key to
start the engine.
TIP
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
If the display indicates any error codes,
note the code number, and then have a
Yamaha dealer check the vehicle.