Advertisement
3.1 Projector Web Control - Network Settings (continued)
2. Infrastructure settings
Item
IP Configuration
SSID *1
Encryption
WEP Key
WPA Passphrase *2
*1 The text length can be up to 32 alphanumeric characters and symbols. Only
symbols "!"#$%&'()*+,-./:;<=>?@[\]^_'{|}~ and space" can be used.
*2 The text length can be 8 to 63 alphanumeric characters and symbols. Only
symbols "!"#$%&'()*+,-./:;<=>?@[\]^_'{|}~ and space" can be used.
NOTE
• If Encryption Lock is ON, wireless connection is performed only when
it can be connected without changing the current settings.
• The channels may vary depending on the country. In addition, depending on
the country or region, it may be required to use a wireless network card that
conforms to the standards in the respective country or region.
• If you connect the projector to an existing network, consult a network
administrator before setting server addresses.
• The projector does not allow both wireless and wired LAN to be connected to
the same network. Do not set the same network address for both wireless and
wired LAN.
Configures the network settings of the projector in
Infrastructure mode.
[DHCP ON]
Enables DHCP.
[DHCP OFF]
Disables DHCP.
Configures IP Address, Subnet Mask, Default Gateway
and DNS server.
Configures the SSID of Infrastructure mode.
Selects data encryption method.
Inputs the WEP key.
Either ASCII characters or hexadecimal numbers can
be used.
However, a combination of both cannot be used.
Encryption
ASCII characters
WEP 64bit
WEP 128bit
Inputs WPA Passphrase.
Description
5 characters
13 characters
3. Web Control
HEX numbers
10 characters
26 characters
45
Advertisement
