Advertisement
2.1.1 Connection in Simple Access Point Mode
Set the following when connecting the projector and the computer in Simple
Access Point mode.
Projector setting
1) Turn on the projector.
2) Press the MENU button on the remote control
or the control panel of the projector.
The MENU you last used will appear.
Use the cursor button to select the following.
EASY MENU > ADVANCED MENU >
NETWORK > NETWORK SETUP >
WIRELESS SETUP
3) Set the following items in WIRELESS SETUP.
• MODE: SIMPLE ACCESS POINT
• IP ADDRESS
• SSID
• SSID BROADCAST
• ENCRYPTION
Select APPLY, then press the ENTER button to reflect the settings.
About network settings
The fourth octet of the projector's IP address is fixed to 1.
Subnet mask of the projector is fixed to 255.255.255.0.
Computer setting
1) The DHCP server function of the projector is always enabled. Enable the DHCP
setting of the computer.
2) Select SSID set for the projector by following the procedure of wireless
connection of the computer. Enter encryption key by following the computer's
instruction if it is encrypted.
NOTE
• As for the procedure of setting network and wireless connection for the
computer, refer to the manual of the computer or wireless LAN device.
• Up to 10 devices can be connected to the projector in Simple Access Point mode.
2. Connection to the network
15
Advertisement
