Advertisement
ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Customer Care section and order the part
needed, e-mail us at customer.care@staminaproducts.com, or call us toll free at 1-800-375-7520
(in the U.S.). Our Customer Care Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central
Time) Monday through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
Some product parts are fit tested at the factory to ensure proper fit and alignment. Marks in
the paint may be noticeable, but are not an indication of damage.
STEP 1:
Refer to the illustration below. Remove the PULL PIN(67) from the REAR FRAME(2). Unfold
the REAR FRAME (2) away from the MAIN FRAME(1). Lock the frame assembly in unfolded position by
inserting the PULL PIN(67) into the hole in the REAR FRAME(2).
NOTE: Refer to the detail view. Remove the PROTECTION TUBE from the back of the REAR
FRAME(2) by removing the BUTTON HEAD BOLTS(M8x40mm) and NUTS(M8). These parts
are only for packing, do not dispose of the packing materials until assembly is completed.
STEP 2:
Attach the REAR STABILIZER(5), the one with LEVELING CAPS(15), to the REAR
FRAME(2) with CARRIAGE BOLTS(M8x1.25x65mm)(52), ACORN NUTS(M8x1.25)(62) and ARC
WASHERS(M8)(63).
STEP 3:
Attach the FRONT STABILIZER(3), the one with WHEEL ENDCAPS(31), to the MAIN FRAME(1)
with CARRIAGE BOLTS(M8x1.25x65mm)(52), ACORN NUTS(M8x1.25)(62) and ARC WASHERS(M8)(63).
Nut(M8)
Protection Tube
Button Head Bolts
(M8x40mm)
Nut(M8)
8
Advertisement
