How To Connect Your Extended Power Cables - Samsung Big Duct Type Series Installation Manual

How to connect your extended power cables

1. Prepare a compressor and the following tools.
Tools
Crimping pliers
Spec
Shape
2. As shown in the figure, peel off the shields from the rubber or wire of
the power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
• After peeling off the tube wire, you must insert a contraction
tube.
CAUTION
• For information about the power cable specifications for indoor
and outdoor units, refer to the installation manual.
3. Insert both sides of core wire of the power cable into the connection
sleeve.
 Method 1
Push the core wire into the sleeve from both sides.
 Method 2
Twist the wire cores together and push it into the sleeve.
4. Using a compressor, compress the two points and flip it over and compress another two points in the same
location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly pressed.
DVM Big Duct_EU_IM_DB68-05047A-01_EN_16.03.30.indd 43
Connection sleeve
(mm)
MH-14 20xØ6.5(HxOD)
 Method 1
Compression
Compress it 4 times.
dimension
Insulation tape
Width 19mm
Power cable (provided by us)
 Method 2
5 mm
Contraction tube (mm)
70xØ8.0(LxOD)
20 20 20
60
120
180
(Unit: mm)
20
Wire tube power cable
Connection sleeve
Connection sleeve
Compress it 4 times.
5 mm
2016/4/7 15:54:57
43