Installing and connecting the device
3.2 Installing the device
3.2
Installing the device
3.2.1
Mounting instructions
Note the following:
• The device is only approved for operation in closed rooms.
• For installation in a control cabinet, observe the SIMATIC installation guidelines and
applicable DIN/VDE requirements or other applicable country-specific regulations.
Securing the device
NOTICE
Insufficient load carrying capacity
If the wall it is mounted on does not have a sufficient load-bearing capacity, the device may
fall and be damaged.
Ensure that the mounting surface on the wall can bear four times the total weight of the
device, including fixing elements.
NOTICE
Incorrect fixing elements
The device may not be securely fitted if you use anchors and screws other than those
specified below for mounting. The device can fall and may be damaged.
Use only the anchors and screws specified in the following table.
26
Operating Instructions, 02/2021, A5E37454814-AE
SIMATIC IPC427E