Log/Trip; 3-Line Page - Raymarine Raydata Installation And Operating Handbook

Chapter 6: The Display Pages

Log/Trip

To display this page, press SPEED from the Speed Through Water
page.
This page shows the log (total distance travelled), and the distance
travelled on the current trip. The distance is in KM, SM, or NM,
depending on the choice made in the Setup pages (see Chapter 4).
You can reset the trip counter, but not the log. To reset the trip counter,
press and hold
the keys down, the trip value flashes until the counter is reset to zero. If
you release the keys after less than three seconds, while the trip value
is still flashing, the trip will not be reset and the display will return to
normal.
The Log counter continues to increase during the lifetime of the
RayData, and cannot be reset except by a factory reset (see page 63).
The maximum distance that can be recorded is 99999.9 KM, SM
or NM.
Press SPEED to display the 3-Line Page.

3-Line Page

This Speed, Depth and Temperature page is also accessed using the
DEPTH key. Refer to page 49 for further information.
Ú Ú Ú Ú Ú Ù Ù Ù Ù Ù
and together for three seconds. While you hold
53