Using The Keys; Turning The Raydata On And Off - Raymarine Raydata Installation And Operating Handbook

18

3.2 Using the Keys

The RayData is controlled using the five keys: NAV (POWER), DEPTH
(LIGHTS), SPEED,
combinations, so that operating your RayData is quick and simple.
There are two ways in which each key can be used:
• Press: Press the key momentarily and then release it.
• Press and hold: Press the key and hold it down for the length of time
stated (for example, three seconds), and then release.
As you press a key, a single beep confirms the key action. If the key
press is not valid for the current screen or mode, three beeps sound to
indicate that no response is available.

3.3 Turning the RayData On and Off

When you turn on the power to the RayData, the keys light up and the
LCD display shows the software version for three seconds. The screen
then automatically changes to show the data that was displayed when
the RayData was last used. If this is the first time the unit has been
turned on, the display shows the depth, as shown in the illustration
below.
Data
type
Data value
Sub-page
availability
indicator
The data displays initially default to imperial units (knots, nautical miles
and feet), but you can change these as described in Chapter 4.
RAYDATA Installation and Operation Handbook
Ú Ú Ú Ú Ú Ù Ù Ù Ù Ù
and . The keys can be used singly or in
NAV DEPTH SPEED
POWER MOB
Units
Text
description
Trend
arrow
Additional
information
RAYDATA
Depth
offset type
LOCK
D3034-1