Adjusting The Deep Alarm Limit - Raymarine Raydata Installation And Operating Handbook

Chapter 5: Alarms
6. When you have set the value to the required number, press
7. If the alarm is off, press and hold
If you do not wish to adjust the deep alarm limits, press DEPTH to return
to the Main Depth page.

Adjusting the Deep Alarm Limit

The minimum and maximum alarm depths you can select, and the
resolution of the alarms, depend on the units selected as follows:
Units
Feet
Fathoms
Metres
The deep alarm limit must also be greater than the shallow alarm limit.
To adjust the deep depth alarm value:
1. Unless you are continuing after setting the shallow alarm, follow
2. Press the
3. Press
4. Adjust the value to the required setting, as described in step 5 in the
5. Press
6. If the alarm is off, press and hold
Press DEPTH to return to the Main Depth page, or
the Anchor Alarm page.
Ú Ú Ú Ú Ú Ù Ù Ù Ù Ù
and together to exit to the Shallow Alarm page, with the new
value set.
to turn it on. The current alarm value is displayed.
Minimum
Depth
10
2
3
steps 1 to 3 in the Shallow Alarm procedure (page 38).
Ù Ù Ù Ù Ù
key to display the Deep Alarm sub-page, showing the
current alarm limit, or ALARM OFF if the alarm is turned off. To
toggle the alarm between on and off, press and hold
together for six seconds.
Ú Ú Ú Ú Ú Ù Ù Ù Ù Ù
and together. The Deep Alarm Adjust page is
displayed.
Shallow Alarm procedure (page 38).
Ú Ú Ú Ú Ú Ù Ù Ù Ù Ù
and together to set the value and return to the Deep
Alarm page.
to turn it on. The current alarm value is displayed.
Ú Ú Ú Ú Ú Ù Ù Ù Ù Ù
and together for six seconds
Maximum
Depth
400
50
120
Ú Ú Ú Ú Ú Ù Ù Ù Ù Ù
and together for six seconds
Ù Ù Ù Ù Ù
39
Resolution
Whole feet
Whole fathoms
Whole metres
Ú Ú Ú Ú Ú Ù Ù Ù Ù Ù
and
to move on to