Immobilizer System - Suzuki NEXA FRONX Owner's Manual & Service Booklet

ignition mode from LOCK (OFF) to ACC
or ON.
• You do not need to keep the engine
switch pressed until the engine starts.
• In the presence of strong radio wave or
noise, you may not be able to change
the ignition mode to ACC or ON or to
start the engine using the engine switch.
In this case, the information display in
the instrument cluster will show the fol-
lowing message.
74TB05005
Unreleased Steering Lock Warning
If the steering lock remains engaged when
you press the engine switch to change the
ignition mode to ON, the information dis-
play in the instrument cluster shows the
following message and you cannot start
the engine. If this happens, press the
engine switch, turning the steering wheel
to right or left.
55T050160
55TB5014
NOTE:
The steering lock may not be released and
the immobilizer/keyless push start system
warning light turns on if some load is
applied on the steering wheel. If this hap-
pens, turn the steering wheel system to the
right or left to relieve it from the load before
you press the engine switch again to
change to the desired ignition mode.
OPERATING YOUR VEHICLE

Immobilizer System

This system is designed to help prevent
vehicle theft by electronically disabling the
engine starting system.
The engine can be started only with your
vehicle's original immobilizer ignition key
or keyless push start system remote con-
troller, which has an electronic identifica-
tion code programmed in it. The key or
remote controller communicates the identi-
fication code to the vehicle when the igni-
tion switch is turned to "ON" position or the
engine switch is pressed to change the
ignition mode to ON. If you need to make
spare keys or remote controllers, see a
Maruti Suzuki authorized workshop. The
vehicle must be programmed with the cor-
rect identification code for the spare. A key
made by an ordinary locksmith will not
work.
In the case you can start the engine, when
you turn the ignition switch to "LOCK" posi-
tion or press the engine switch to change
the ignition mode to ON, the immobilizer
system will be released and the immobi-
lizer/keyless push start system warning
light will turn on for about 2 seconds and
then it will turn off.
When you turn the ignition switch to
"LOCK" position or press the engine switch
to change the ignition mode to LOCK
(OFF), the immobilizer system will operate.
55TH0-74E
5-6