Suzuki NEXA FRONX Owner's Manual & Service Booklet page 133

INSTRUMENT CLUSTER
You can check transition of average fuel
consumption every 5 minutes from 15 min-
utes before up to now. Also, you can check
transition of average fuel consumption the
past 3 driving cycles. Time indication and
driving cycle indication can be changed.
For details, refer to "Setting mode" in this
section.
Driving range
(8)
52RM21090
(8) Driving range
If you selected driving range the last time
you drove the vehicle, the display indicates
"---" for a few seconds and then indicates
the current driving range when the ignition
switch is turned to "ON" position or the
engine switch is pressed to change the
ignition mode to ON.
The driving range shown in the display is
an indicative unit of the approximate dis-
4-21
tance you can drive until the fuel gauge
indicates "E", based on current driving con-
ditions and current fuel level in the fuel
tank.
When the low fuel warning light comes on,
the display "---" will appear.
If the low fuel warning light comes on, fill
the fuel tank immediately regardless of the
value of driving range shown in the display.
When you refuel, the driving range is
updated. However, if you only add a small
amount of fuel, the correct value will not be
displayed.
NOTE:
• If you refuel when the ignition mode is
"ON", the driving range may not indicate
the correct value.
• When you reconnect the negative (–)
terminal to the lead-acid battery, the
value of driving range will be shown after
driving for a period of time.
• If there are substantial changes in the
driving pattern or vehicle usage, the dis-
played range may vary significantly.
Average speed / 5-minute average
speed
Average speed from previous reset and 5-
minute average speed are shown.
(Average speed)
(9)
52RM21100
(9) Average speed
If you selected average speed the last time
you drove the vehicle, the display indicates
the last value of average speed from previ-
ous driving when the ignition switch is
turned to "ON" position or the engine
switch is pressed to change the ignition
mode to ON. Unless you reset the value of
average speed, the display indicates the
value of average speed which includes
average speed during previous driving.
To reset the value of average speed, push
and hold the indicator selector knob (3) for
about 2 seconds when the display indi-
cates an average speed. The display
55TH0-74E