Suzuki NEXA FRONX Owner's Manual & Service Booklet page 105

Table of Contents

Advertisement

BEFORE DRIVING
2) The lighting switch is in "AUTO" posi-
tion.
3) You turn the ignition switch to "ON"
position or press the engine switch to
change the ignition mode to ON.
This system is activated by a signal from
the light sensor (5) on the passenger side
of instrument panel. Do not cover the sen-
sor (5). Otherwise, the system will not work
correctly.
WARNING
It takes about 5 seconds for the light
sensor to react to a change in light-
ing conditions. To help avoid an acci-
dent due to reduced visibility, turn on
your headlights before driving into a
tunnel, parking structure, etc.
NOTE:
The light sensor reacts even to infrared
rays, so it may operate incorrectly when
there are strong infrared rays.
3-23
Light Reminder Buzzer
The interior buzzer continuously beeps if
you open the driver's door without turning
off the headlights and position lights. This
function is triggered under the following
condition:
The headlights and/or position lights are
on even after the ignition switch is turned
off, or the engine switch is pressed to
change the ignition mode to LOCK (OFF).
The buzzer stops sounding when you turn
off the headlights and position lights.
NOTE:
A message is indicated on the information
display in the instrument cluster while the
buzzer is sounding.
Daytime Running Light (D.R.L.)
System (if equipped)
When the engine is started, the daytime
running lights are turned on by this system.
Conditions for D.R.L. system operation
1) The engine is running.
2) Headlights are off.
NOTE:
Brightness of the daytime running lights is
different from the brightness of the position
lights, but it is not a malfunction.
Guide Me Light (if equipped)
Guide me light has two functions of "To
home" and "To car" for improving your visi-
bility in the dark.
"To home" function
Even after you leave the car, the ground
will be illuminated for a short while with this
function. You can turn on the front position
lights and the headlights in the low beam
setting for about 10 seconds after the igni-
tion switch is turned to "LOCK" position or
the engine switch is pressed to change the
ignition mode to LOCK (OFF).
To set the function:
1) Turn the lighting switch to "AUTO" posi-
tion.
2) Turn the ignition switch to "LOCK" posi-
tion or press the engine switch to
change the ignition mode to LOCK
(OFF).
3) Pull the lighting control lever toward
you once and open the driver's side
door within 60 seconds. Or pull the
lighting control lever toward you once
while the driver's side door is open.
55TH0-74E

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents