Table of Contents
Advertisement
at our Product Repair Center. We will do everything possible to return your unit as quickly as
possible. To inquire about the status of your unit our Product Repair Center may be reached
at the number below. Please keep a record of the serial number of your unit and have this
number ready when you call.
Product Repair Center : 1-800-539-5539 ext. 2118.
In Europe, Raytheon equipment may be returned for service at the following address:
Raytheon Marine Europe Limited
Anchorage Park, Portsmouth
PO3 5TD. England
ATT. Service Department
Phone (01705) 693611
Fax
(01705) 694642
5.2
PREVENTATIVE MAINTENANCE
The RAY106 has been constructed to be virtually maintenance free. Your attention to a few
basic points should assure many years of service.
Although the unit is waterproof, always keep the unit as dry as reasonably possible.
Clean the exterior of the unit with a tissue or soft non-abrasive cloth. Do not use
solvents or other chemicals.
Inspect the radio case, battery pack, and antenna for any physical damage.
Check the antenna connector for any dirt or corrosion.
The following alignment procedures have been provided in this manual
to aid FCC licensed technicians and service personnel only.
5.3
ALIGNMENTS AND SERVICE
This transceiver is completely aligned at the factory and does not require any adjustments at
installation.
The test equipments listed are used for the test setup shown in Fig. 5-1. This test setup is
used either in part or in total during the following adjustments.
TEST EQUIPMENT
1. DC Power Supply (0-20 V variable, 3A max.) set at 7.2 VDC
2. RF Power Meter (10 W, 50 ohm, 150-200 MHz)
3. RF Signal Generator (50 ohm Output, 150-200 MHz)
4. FM Linear Detector (FMLD) or Deviation Monitor 150-200 MHz
5. Frequency Counter
6. Digital Voltmeter
7. Oscilloscope (any oscilloscope accurate for audio signal tracing)
8. SINAD Meter
9. Distortion Meter
10. Toggle Switch (for use as a PTT twitch)
11. Coaxial Switch for TX/RX Antenna switching
NOTE:
Advertisement
Table of Contents
