Lcd Display - Raymarine Ray 106 User Manual

3.2.2 LCD Display

A number of indicators appear on the LCD display in different locations. The following list
describes each indicator and when it will appear.
À
MEM (Memory) : will be displayed when the current channel is a memory channel, and in
Memory Scan/Seek mode.
Á
SCAN (All Scan/Memory Scan) : will be displayed when the radio is in the All Scan or
Memory Scan mode.
Â
MON (Monitor) : will be displayed when the radio is in the Monitor mode.
Ã
WX (Weather) : will be displayed when a weather channel is selected. The "WX" indicator
will blink when a severe weather alert tone is received (in Monitor mode).
Ä
SEEK (All Seek/Memory Seek) : will be displayed when the radio is in the All Seek or
Memory Seek mode.
Å
INT (International) : will be displayed when International channels are programmed for use.
Æ
5 / 3 / 1 : will be displayed to indicate the current TX power setting.
Ç
TX (Transmit) : will be displayed on the LCD when the Push-To-Talk (PTT) switch on the
radio is engaged and the transmitter circuits are providing RF signals to the antenna.
È
BATT : is always shown on the display along with the battery voltage bar indicators to
provide a battery level status. The "BATT" indicator will blink when the battery voltage is
low, and the battery needs charging. If a low battery condition is detected during
transmission, "LO" will be shown and the radio will stop transmitting. The battery level is
shown on the LCD as follows:
É
LARGE CHANNEL # : displays the channel number currently in use.
SMALL CHANNEL # : displays the channel number of the priority channel in Monitor mode.
Fig. 3-2 LCD DISPLAY
Battery condition
Fully charged
Normal operation
Needs charging
Other indicators shown in the Small Channel segment area:
L : indicates Key Lock mode.
C : indicates Canada mode.
P : indicates Priority mode.
LCD Indicator
BATT — — —
BATT — —
BATT —