The 16Plus (Priority) Channel; Memory Key Functions; All Scan And Memory Scan Modes - Raymarine Ray 106 User Manual

3.3.2 The 16PLUS (priority) Channel

The 16plus priority channel has been preset to CH16 prior to shipment from the factory.
However, an alternate working channel can be selected as the priority channel if desired, using
the procedure below.
1) Press the 5/6 channel keys to select the desired channel.
2) Press and hold the 16plus key for three seconds. An audible beep tone will confirm that the
selected channel is stored in memory as the new priority channel.
3) To reprogram CH16 as the 16plus channel, repeat steps 1 and 2 for CH16. WX channels
cannot be programmed as the priority channel.

3.3.3 Memory Key Functions

The MEM key is used to program channels into memory for Memory Scan and Memory seek
functions, and for the Memory Recall function.
To program a channel into memory, select the channel to be stored using the 5/6
channel keys. Press and hold the MEM key for about 2 seconds. The MEM indicator will
appear on the display, and a beep tone will confirm that the channel has been stored to
memory. There is no limit to how many channels can be stored to memory.
To clear a channel from memory, select the channel to be cleared using the 5/6
channel keys. Press and hold the MEM key for about 1 second. The MEM indicator will no
longer be shown on the display and a beep tone will confirm that the channel has been
erased from memory.
To review the memorized channels (Memory Recall), press the MEM key twice. The
channels that have been stored into memory will be displayed in sequence on the LCD for
review.
3.3.4 Memory Reset
To clear all channels from memory, and reset the 16plus key to it's factory default channel
(CH16), hold the MEM key down while turning the radio ON.

3.3.5 All Scan and Memory Scan Modes

1) All Scan
Press the SCAN/SEEK key, to activate the All Scan mode. The SCAN indicator will appear
on the display and the RAY106 will sequentially scan all of the channels in the selected
frequency mode (U.S., INT, or Canada).
If a signal is received, the scanning will stop until the station clears. After 5 seconds,
scanning will resume. If the scanning has stopped on a received signal, press the
SCAN key again to continue. To cancel the SCAN mode, press the SCAN key.
If the scanning has stopped on a channel with traffic, and you wish to communicate
with the other party, press the PTT switch to cancel the SCAN mode and remain on
that channel.