Lcd Display; Operating Proced,,Res - Raymarine Apelco 5200 User Manual

3.2.2 LCD Display

A number of characters appear on the LCD display in different locations. The following list
describes the characters as well as when and where they will appear.
w x
MONITOR
SCAN: Will flash by itself when All-Scan mode is to be initiated or will flash in unison with
"MEMORY' when Memory Scan mode is to be initiated.
1 WATT (High/Low Power): Will be displayed when the transmitter circuits are providing I
Watt of power to the antenna. When the transmitter is supplying 25 Watts to the antenna,
the "1 WATT" indication will be extinguished.
ALERT (Weather Alert): Will blink when a Weather Alert Tone has been detected.
MONITOR: Will be displayed when the MON/INT
is in the MONITOR mode.
indicating the transmitter circuits are providing a signal to the antenna.
when the radio is programmed to the MEMORY SCAN mode.
3.3 OPERATING PROCEDURES
Specific operating procedures for the VHF5200 are presented in this section, General informa-
tion regarding corrrect marine channel usage may be found in the Appendix section. Refer to
the Controls section 3.2.1 beginning on page 10 for a thorough description of all VHF5200
functions.
I
1 WATT SCAN
I
ALERT
TX INT MEVORY
Fig. 3-2 LCD DISPLAY
key is pressed. This indicates the radio
11