Raymarine Apelco 5200 User Manual page 18

-With no channels entered in memory:
When pressed once, "SCAN" will begin to flash on the LCD and Ail-Scan will be initiated in three
seconds. To stop scanning, press the "SCAN" key again.
-With one or more channels entered in memory:
When pressed once, "SCAN" and "MEMORY" will begin to flash on the LCD and Memory Scan
will be initiated in three seconds. To stop the unit from scanning, press the "SCAN" key again.
-With one or more channels entered in memory:
When pressed once, "SCAN" and "MEMORY" will begin to flash on the LCD.
within three seconds, "MEMORY" will disappear and "SCAN" will continue flashing indicat
ing All-Scan is now the selected mode and will be initiated in three seconds.
More detailed operational information is available in Section 3.3.4 Scan Modes.
When the "SCAN" key is pressed and held for two seconds, "MEMORY" will appear on the
LCD and the channel that is selected when the key is pressed will be stored in memory. A
channel may be removed from memory by selecting the channel to be removed and press
ing and holding the "SCAN" key again for two seconds. "MEMORY" will disappear from the
LCD. Weather channels can not be placed into memory.
PTT (Push-To-Talk) Switch
When pressed, puts the radio into the transmit mode and "TX" will be displayed on the LCD.
All of the above keys except PlTwill produce an audible "beep"when pressed.
Fig. 3-1 LAYOUT OF CONTROLS AND CONNECTORS
Channel ,-a
1 0
If pressed again