Remove The Dell Hba350I Adapter - Dell HBA 355 Series User Manual

NOTE: To prevent damage to the card, you must hold the card by its edges only.
4. Press the HBA card onto the connector until it is firmly seated.
5. Press the release latch to secure the card to the sled.
6. Connect the SAS cable connectors to the card.
NOTE: Ensure that you connect the cable according to the connector labels on the cable. If reversed, the cable does
not function properly.
7. Route the SAS data cable through the clip on the card and through the channel on the inner side of the chassis.
8. Attach the connector that is labeled BP SAS to connector SAS A on the backplane, and attach the connector that is labeled
CTRL SAS to SAS-cable on the controller card.
9. Install the system cover.
10. Insert the sled into the chassis and turn on the system and any attached MX chassis peripherals.
Figure 21. Install Dell HBA350i MX

Remove the Dell HBA350i Adapter

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
● You have read and complied with the safety guidelines listed in
● You have completed the procedures in
Steps
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
2. Remove the system cover.
Safety
Before working inside your
instructions.
system.
Installation and removal of cards 33