Install The Dell Hba355I Front - Dell HBA 355 Series User Manual

For systems configured with HBA355i Front in an upside-down orientation, reattach the HBA355i Front to the backplane
before reinstalling the backplane into the system.
8. Install the system cover.
9. Reconnect the system to its electrical outlet, and turn the system on, including any attached peripherals.
Figure 9. Remove HBA355i Front

Install the Dell HBA355i Front

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the system cover.
3. Connect the SAS data cable connectors to the card.
NOTE: Ensure that you connect the cable according to the connector labels on the cable. The cable does not function
properly if reversed.
4. Align the card-edge connector with the connector on the system board.
Installation and removal of cards 25