Table of Contents
Advertisement
Backhaul FM4200 Mobi
Cisco Ultra-Reliable Wireless
3. Remove the protective plastic cover
from the port labelled DC IN.
5.2.3. Connecting LAN cables to the unit
M12X LAN cables
When the Cisco FM4200 Mobi is mounted in its final location, connect the
unit to LAN connection(s) and/or a PoE power supply by doing the
following steps:
1.
Only use a shielded CAT5/6 cable that terminates in an M12X
connector to connect any LAN cable to the unit.
© 2020 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
If a local area network (LAN) connection must be made to the
unit and the unit must be powered using a compatible network
switch or PoE injector, follow the instructions in this section.
If non-powered local area network (LAN) connections must be
made to the unit through both LAN ports, follow the instructions
for connecting the LAN cables as shown in this section. Then,
connect a 48V DC IN power supply to the unit as shown in
"Connecting a DC IN power source to the unit" (page
4. Wrap PTFE thread-sealing tape around the
threads of the M12A connector on the unit. Use
enough tape to ensure a watertight seal.
5. Insert the M12A connector leading from the
power source into the port labelled DC IN.
6. Screw the threaded sleeve of the male
connector onto the female connector. Tighten the
connection by hand.
37).
Page 38 of 177
Advertisement
Table of Contents
