Backhaul FM4200 Mobi
Cisco Ultra-Reliable Wireless
Figure 40. SNMP dialog (SNMP disabled)
Using SNMP v2c
To change the unit's SNMP mode to v2c and configure the unit
accordingly, do the following steps:
1.
Click the SNMP mode drop-down, and click the v2c option.
• The SNMP v2c settings dialog will be shown
2.
Enter a community identity value in the Community ID: field.
© 2020 Cisco and/or its affiliates. All rights reserved.
NOTE
By default, Fluidmesh units are shipped from the
factory with SNMP disabled.
(page
104)).
Figure 41. SNMP dialog (v2c selected)
IMPORTANT
The same community identity value must be set for
all Fluidmesh units in the wireless network.
(Figure 41
Page 104 of 177