Baumatic BR105 Instruction Manual page 20

o Insert the retaining screws (1) into the opposite side of the
appliance from their original position. These screws should be
partially tightened but not fully tightened.
o Remove the door retaining screws (2) and then reverse the
position of the top and bottom hinge (as shown in the above
diagram).
o Reattach the appliance door and then fully re-tighten the
retaining screws (1) and the door retaining screws (2).
o Insert the cover caps (3) into the holes that are now exposed on
the right hand side of the cabinet.
I MPORTANT: Check that the door opens and shuts correctly,
without fouling, after you have completed the door reversal
process.
After the door has been reversed, you should check
the door seal of the appliance. The seal should not
be creased or crushed; otherwise there will be a gap
between it and the inside of the door.
The seal must adhere properly all the way around the door.
o
o If the seal is not adhering to the cabinet properly, then you
should either:-
1. Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
I MPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
THE DOOR SEAL, WHICH WOULD NOT BE RECTIFIED UNDER
THE GUARANTEE FREE OF CHARGE.
20