Jonsered CS 2166 Workshop Manual page 46

4. Locate the guide pegs in the clutch side crankcase
half, grease and locate the gasket. See fig. 12.
NOTE!
Continuing to pull with the assembly tool
after the gasket is clamped will damage the
crankshaft.
5. Use tool 502 50 30-14 and pull on the flywheel side
crankcase half. Pull until the gasket is clamped
between the two halves. See fig. 13.
6. Insert the six bolts and tighten them in rotation.
Tighten them finally to 8 Nm. See fig 14.
NOTE!
Ensure that excess gasket material does not
fall into the crankcase.
7. Cut off excess gasket at the level of the cylinder
seating plane.
8. Refit the carburettor space bottom plate with the four
bolts. Tighten to 5 Nm.
9. Refit the following components:
A. Tank unit.
B. Piston and cylinder.
C. Silencer.
D. Carburettor.
E. Lubrication system.
F. Centrifugal clutch.
G. Electrical system.
H. Recoil starter.
I. Chain and guide bar.
10. If a new crankshaft has been fitted the saw must be
run in for 3-4 hours at the carburettor base settings.
46 – English
CRANKCASE AND CRANKSHAFT
Fig. 12
Fig. 13
Fig. 14