Jonsered CS 2166 Workshop Manual page 13

Reassembly
Assemble the chain brake as follows:
1. Reattach the toggle joint and brake-strap. See fig. 5.
2. Grease the toggle joint (E) moving parts and locate
the assembly in the chainsaw. See fig. 6.
3. Grease and insert the lever arm (D). See fig. 3.
4. Grease and insert the retaining bush (C) and spring.
See fig. 3.
5. Locate the chain brake assembly cover, four bolts
(B). Tighten the screws to 4 Nm. See fig. 1.
6. Locate the chain guide-plate with bolt (A). See fig. 1.
7. Attach the hand guard with the sleeving on the
starter side. See fig. 2.
8. Draw back the hand guard so that the chain brake is
in the off position.
9. Check that the brake-strap is seated correctly in the
recess (F) in the crankcase. See fig. 6.
10. Assemble the following components:
• Centrifugal clutch
• Chain and guide bar.
Checking brake operation
!
WARNING!
After repair, the chain brake must be
checked in accordance with the fol-
lowing instructions.
For this test, the motor should not be running.
Test the chain brake cut in as follows:
1. Hold the saw over a stable surface as shown in fig. 7.
The distance between the guide bar and the
surface is given in the table below.
Guide bar length, L Height, H
15-20 inches
21-28 inches
29-32 inches
2. Let go of the front hand grip and let the chainsaw
pivot round on the rear hand grip.
3. When the guide bar hits the surface, the chain brake
should cut in.
SAFETY EQUIPMENT
50 cm
70 cm
80 cm
min. 0,8 mm
Fig. 5
F
Fig. 6
Fig. 7
E
C
L
H
English – 13