Cleaning and inspection
Clean all components and check that the fuel line is
undamaged.
Reassembly
1. If the chainsaw is equipped with hand grip heating,
refit the heating element into the rear hand grip,
if it has been removed.
2. If a new fuel hose is to be fitted, proceed as follows:
A.
Lightly oil in one half of the new fuel hose.
B.
Thread in the oiled part through the hole in
the tank unit. Allow 80-85 mm to protrude on the
outside. See fig. 4.
C.
Twist the hose so that it is bent upwards.
See fig. 4.
D.
Cut off the angled ends of the hose so
that it protrudes 70-75 mm on the outside.
E.
Remove the hose from the tank and fit the
fuel filter. Push on the hose as far as it will go.
3. If the front hand grip has been removed, refit it.
Tighten the bolts to 4 Nm.
NOTE!
Ensure that the fuel hose and throttle cable
are not damaged.
4. If the throttle lock has been removed, it
should be refitted before the tank unit and motor unit
are reassembled. See page 15.
5. Lift the motor unit over the tank unit and push the
fuel line and throttle cable into their holes in the
bottom of the carburettor space.
6. Reconnect the leads to the stop switch.
7. Turn the tank unit a little towards the flywheel side so
that the fixed travel limiter is in the correct position.
8. Refit the bolt (F) on the flywheel side. See fig. 5.
Tighten to 6 Nm.
9. Fit the bolts (C and D), chain catcher
and travel limiter bolt (E) on the clutch side.
See fig. 6. Tighten the bolts to the torque shown on
the diagram.
10. If the saw is equipped with hand grip heating,
reconnect the lead at C.
11. Reconnect the fuel line (B) to the carburettor.
See fig. 7.
12. Insert the throttle cable outer into its location and
reconnect the throttle cable (A) to the carburettor.
See fig. 7.
13. Refit the cylinder cover, chain and guide bar.
TANK UNIT
Fig. 4
Fig. 5
Fig. 6
A
Fig. 7
F
B
English – 37