Assembly - Grizzly G0656P Instruction Manual

Assembly

To assemble the jointer:
1.
Carefully lay the stand on its side so you can
access the underside.
2. Bolt the wheel assembly to the stand with the
provided hardware, as shown in Figure 7.
Note: Refer to the Inventory List on Page
11 for a list of components needed for ass-
sembly.
Hex Bolt M8-1.25 x 50
Hex Bolts M10-1.5 x 55
Flat Washers 10mm
Figure 7. Example of bolting the wheel assembly
to the stand.
3. Turn the stand rightside up.
The jointer is heavy. Seek
assistance when lifting it
onto the jointer stand.
4.
Remove the rear access panel from the
jointer stand.
-14-
Flat Washer 8mm
Hex Nuts
M10-1.5
5.
With the help of an assistant, lift the jointer
onto the stand.
6.
Align the mounting holes on the jointer and
stand.
7. Secure the jointer to the stand with the
M8-1.25 x 50 cap screws, washers, and hex
nuts, as shown in Figure 8.
Jointer
Stand
Figure 8. Jointer secured to stand.
8.
Using a 13mm wrench, loosen the motor
bracket fasteners shown in Figure 9.
Note: DO NOT completely remove the motor
mount bolts.
Figure 9. Motor bracket fasteners (black
arrows); motor mount fasteners (white arrows).
Model G0656 (Mfg. since 10/07)
Cap Screw
M8-1.25 x 50
Flat Washer 8mm
Flat Washer 8mm
Lock Washer 8mm
Hex Nut M8-1.25